I cut the Pside cabinet doors today, bit of a challenge. I wanted enough material to hold it together. I cut off the bottom section flush to the top of the lower curve. Next I measured where the seam should be to make the height right. I added the width of the bottom section  to where the inner plate should be and cut it. Then I cut out the upper section in 2 cuts, sparks flying as I cut through the nails. It works, a bit of glue and some fillers, sanding will do.


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s